ALUTECH Group of Companies informs you about extending new options for sectional doors. In particular, the following options are available for order:

• false-panel with single glazing for panoramic doors series AluTrend;
• opportunity to extend shaft at optional length;
• complete set of reinforcing profiles for a door leaf.

FALSE-PANEL WITH SINGLE GLAZING FOR DOORS SERIES ALUTREND

False-panel with single glazing can be installed together with panoramic doors series AluTrend. It is used for partial overlapping of the entry opening proximately under the headroom.

Leafs of false-panel and panoramic doors are manufactured from identical extruded aluminum profiles, which ensure their laconic external view. However, the number of false-panel imposts corresponds to the number of imposts in panoramic doors. Minimum height of false panel in panoramic doors is 300 mm, maximum is 4155.

Panoramic doors and false-panel with single glazing look really appealing, and are distinguished by attractive price and can be applied in regions with warm climatic conditions.

SHAFT EXTENSION AT OPTIONAL LENGTH

Another one new commercial position for ALUTECH sectional doors allows to extend torsion shaft from 300 mm up to 1300 mm (in 100 mm increments). It is applied in doors with torsion springs of all mounting types both with manual and automatic operating mode.

This option will be in high demand on the facilities, where in headroom zone lines of communication are located, which block installation of shaft electric drive or a chain host.

Please, note, that despite the new market option in the ALUTECH Group of Companies product range, commercial position “shaft length extension” (art. ELS) with the opportunity to extend shaft length to the fixed dimension — up to 300 mm — is still available for order.

COMPLETE SET OF REINFORCING PROFILES FOR A DOOR LEAF

In order to improve wind-resistance of ALUTECH sectional doors, we would like to introduce to the range new complete set of reinforcing omega-profiles. They ensure additional rigidity of the door leaf, enhance resistance to deformation and wind load.

Reinforcing profiles of new complete set are mounted on each sandwich-panel, except for panels with inbuilt wicket, aluminum panoramic panels and panels of height less than 625 mm with windows.

It is recommended to mount these profiles on the doors located in regions with high wind load (coastal regions, mountainous areas, etc.), and also on large-sized doors (with width of 5000 mm and more), which are mounted in heated spaces or in facilities, where temperature difference between external and internal surfaces may exceed 40°С. Also these profiles can be applied in manufactured objects dyed in dark colours and mounted on the side exposed to the sun.

We would like to draw your attention that at the present moment complete sets of reinforcing profiles are presented by two commercial positions. Detailed information is represented in the Figure below.

Comparison of complete sets of reinforcing profiles for a door leaf

Product name	Technical characteristics	Optional	Standard set
Set of reinforcing profiles, art.SPK-110	58х110 mm(WхH)	Industrial doors series ProPlus and ProTrend of width from 5000 mm up to 7000 mm (all mounting types)	-
Set of reinforcing profiles, art.SPK	36,2х78 mm(WхH)	Garage and industrial doors with torsion springs of width up to 4995 mm (4500 mm for doors of high and vertical mounting types)	Garage and industrial doors with torsion springs of width from 5000 mm (4505 mm for doors of high and vertical mounting types)

Сost calculation of ALUTECH sectional doors with new options is already available on AService portal, which make the order process and commercial offer preparation very easy.

We are sure that new options will be in high demand among clients and make operation process of sectional doors even more convenient.